DC Power flow¶
Warning
To run an AC power flow with DC power flow initialization, use the AC power flow with init=”dc”.
pandapower uses PYPOWER to solve the DC power flow problem:

pandapower.
rundcpp
(net, trafo_model='t', trafo_loading='current', recycle=None, check_connectivity=True, r_switch=0.0, **kwargs)¶ Runs PANDAPOWER DC Flow
 INPUT:
 net  The pandapower format network
 OPTIONAL:
trafo_model (str, “t”)  transformer equivalent circuit model pandapower provides two equivalent circuit models for the transformer:
 “t”  transformer is modeled as equivalent with the Tmodel. This is consistent with PowerFactory and is also more accurate than the PImodel. We recommend using this transformer model.
 “pi”  transformer is modeled as equivalent PImodel. This is consistent with Sincal, but the method is questionable since the transformer is physically Tshaped. We therefore recommend the use of the Tmodel.
trafo_loading (str, “current”)  mode of calculation for transformer loading
Transformer loading can be calculated relative to the rated current or the rated power. In both cases the overall transformer loading is defined as the maximum loading on the two sides of the transformer.
 “current” transformer loading is given as ratio of current flow and rated current of the transformer. This is the recommended setting, since thermal as well as magnetic effects in the transformer depend on the current.
 “power”  transformer loading is given as ratio of apparent power flow to the rated apparent power of the transformer.
recycle (dict, none)  Reuse of internal powerflow variables for time series calculation
Contains a dict with the following parameters: _is_elements: If True in service elements are not filtered again and are taken from the last result in net[“_is_elements”] ppc: If True the ppc (PYPOWER case file) is taken from net[“_ppc”] and gets updated instead of reconstructed entirely Ybus: If True the admittance matrix (Ybus, Yf, Yt) is taken from ppc[“internal”] and not reconstructedcheck_connectivity (bool, False)  Perform an extra connectivity test after the conversion from pandapower to PYPOWER
If true, an extra connectivity test based on SciPy Compressed Sparse Graph Routines is perfomed. If check finds unsupplied buses, they are put out of service in the PYPOWER matrixr_switch (float, 0.0)  resistance of busbusswitches. If impedance is zero, buses connected by a closed busbus switch are fused to model an ideal bus. Otherwise, they are modelled as branches with resistance r_switch
**kwargs  options to use for PYPOWER.runpf
Note
If you are interested in the pypower casefile that pandapower is using for power flow, you can find it in net[“_ppc”]. However all necessary informations are written into the pandpower format net, so the pandapower user should not usually have to deal with pypower.